G930UUEU2APG9 US Unlocked Galaxy S7 SM-G930U Android 6.0.1 Marshmallow Stock Firmware

US Unlocked Galaxy S7 SM-G930U - Android 6.0.1 Marshmallow Stock Firmware build version G930UUEU2APG9.

DeviceGalaxy S7 SM-G930U
Android version6.0.1 (Marshmallow)
Android security patch levelAugust 1, 2016
Baseband versionG930UUEU2APG9
Kernel version3.18.20-8719017
Build numberMMB29K.G930UUEU2APG9
Build dateMon 8 August 2016

You might also check first the newest firmware released : US Unlocked Galaxy S7 SM-G930U Stock Firmware

Stock Firmware build G930UUEU2APG9 - US Unlocked Galaxy S7 SM-G930U

Tips: The US unlocked Galaxy S7 G930U stock firmware are identical to each other, no matter of which carrier's SIM card the device has. If you flashed the ATT on VZW one, it made no difference at all. The only thing it might can do is that you can easily update the device without any hiccups when a new update rolls out.

Carrier/ NetworkStock  builds
 AT&T ATT - (link)
 Verizon VZW - (link)
 T-Mobile TMB - (link)
 Sprint SPR - (link)
 Virgin-Mobile VMU - (link)
 Boost Mobile BST - (link)
 TracFone TFN- (link)
 Bluegrass Cellular LRA - (link)

How to Use a Stock Firmware?

Read the Full Detailed Instructions: How to Install a Stock Firmware on a Galaxy S7 or a S7 Edge 

This stock firmware can only be use on US Unlocked Galaxy S7 SM-G930U only.  It can be use either to manually update the device, unroot and restore it back to its original Android OS state, and if the device has been modified in unauthorized way and no longer receives OTA updates.

Flashing Instructions

  1. Connect the phone to PC using the USB data cable.
  2. Reboot the phone in Download Mode (press and hold Home + Power + Volume Down buttons)
  3. Extract and run Odin3 multi-flasher .
  4. Extract the firmware package.
  5. Grab Odin3 Multi-flasher and install the phone’s USB driver.
  6. Backup all important data stored in the phone’s memory, such as contact, messages, music, videos, pictures, documents, and more.
  7. Recharge the phone or it should have at-least 50% remaining power.
  8. Load the firmware file:
    • Multiple packed – load each file in Odin3’s designated slots, such as AP,  BL, CP,  and CSC button.
    • Single file –
    load in the AP button
  9. Make sure the Odin's Re-partition option is NOT ticked.
  10. Click the Start button, wait for a couple minutes until the installation finishes.

You may also perform the factory data reset to obtain a fresher and cleaner firmware installation. Doing so after every new update is installed will get rid of lag issues.