G935UUEU4APL4 US Unlocked Galaxy S7 edge SM-G935U Android 6.0.1 Marshmallow Stock Firmware

US Unlocked Galaxy S7 edge SM-G935U Firmware version G935UUEU4APL4 Android 6.0.1 Marshmallow

DeviceGalaxy S7 edge SM-G935U
Android version6.0.1 (Marshmallow OS)
Android security patch levelDecember  1, 2016
Baseband versionG935UUEU4APL4
Kernel version3.18.20-9978521
Build numberMMB29K.G935UUEU4APL4

You might also check the latest firmware update here : US Unlocked Galaxy S7 edge SM-G935U Stock Firmware

Stock Firmware Usage

This Stock firmware can only be use on a US factory unlocked Galaxy S7 edge SM-G935U only.  It can be use either to manually upgrade, unroot, as well as to fix the phone if bricked (such as bootloop, stuck in Samsung logo splash screen).  This firmware can restore the Galaxy S7 edge G935U to its original Android operating system.  You may use it only if the device has been modified in unauthorized way and if the device no longer receives an OTA update.

Stock firmware were also a handy tool to fix if one have messed-up and ended up the device into a soft-bricked state, such as bootloop (the phone keeps on restarting all over and over again), or the phone just stuck in a Samsung logo.

The US unlocked Galaxy S7 edge G935U shares similar firmware build version, no matter of which carrier's SIM Card your device have been used to.
You might also check the latest firmware update here : US Unlocked Galaxy S7 edge SM-G935U Stock Firmware

Instructions :

Read the Full Detailed Instructions: How to Install a Stock Firmware on a Galaxy S7 or a S7 Edge 
  1. Connect the phone to PC using the USB data cable.
  2. Reboot the phone in Download Mode (press and hold Home + Power + Volume Down buttons)
  3. Extract and run Odin3 multi-flasher .
  4. Extract the firmware package.
  5. Grab Odin3 Multi-flasher and install the phone’s USB driver.
  6. Backup all important data stored in the phone’s memory, such as contact, messages, music, videos, pictures, documents, and more.
  7. Recharge the phone or it should have at-least 50% remaining power.
  8. Load the firmware file:
    • Multiple packed – load each file in Odin3’s designated slots, such as AP,  BL, CP,  and CSC button.
    • Single file –
    load in the AP button
  9. Make sure the Odin's Re-partition option is NOT ticked.
  10. Click the Start button, wait for a couple minutes until the installation finishes.

You may also perform the factory data reset to obtain a fresher and cleaner firmware installation. Doing so after every new update is installed will get rid of lag issues.