G935UUEU4BQD2 US Unlocked Galaxy S7 edge SM-G935U Android 7.0 Nougat Stock Firmware

Here's the official Android 7.0 Nougat Firmware version G935UUEU4BQD2 for US Unlocked Galaxy S7 Edge SM-G935U variant. This the first Android 7.0 Nougat released builds, and were officially rolled out on May 2017.

DeviceGalaxy S7 edge SM-G935U
Android version7.0 (Nougat)
Android security patch level2017-04-01
Baseband versionG935UUEU4BQD2
Kernel version3.18.31-10860000
Build numberNRD90M.G935UUEU4BQD2
Build dateTue 11 April 2017

Download G935UUEU4BQF3 Stock Firmware – Odin Flashable Package

You may only use the latest firmware update as includes but not limited to, new or enhanced Apps and Features,  device stability, fixes and resolves known issues, additional improvements to the device performance such as camera, data connectivity, audio and video quality, and various system improvements.

The US unlocked Galaxy S7 edge G935U shares similar firmware build version, no matter of which carrier’s SIM Card your device have been used to.

 Carrier CSC Firmware Downloads
 AT&T ATT Download
 T-Mobile TMB Download
 Sprint SPR Download
 Verizon VZW Download
 Boost Mobile BST Download
 TracFoneTFN Download
 US CellularUSC Download

You might also check the latest firmware update here : US Unlocked Galaxy S7 edge SM-G935U Stock Firmware

Instructions :

Read the Full Detailed Instructions: How to Install a Stock Firmware on a Galaxy S7 or a S7 Edge 
  1. Connect the phone to PC using the USB data cable.
  2. Reboot the phone in Download Mode (press and hold Home + Power + Volume Down buttons)
  3. Extract and run Odin3 multi-flasher .
  4. Extract the firmware package.
  5. Grab Odin3 Multi-flasher and install the phone’s USB driver.
  6. Backup all important data stored in the phone’s memory, such as contact, messages, music, videos, pictures, documents, and more.
  7. Recharge the phone or it should have at-least 50% remaining power.
  8. Load the firmware file:
    • Multiple packed – load each file in Odin3’s designated slots, such as AP,  BL, CP,  and CSC button.
    • Single file –
    load in the AP button
  9. Make sure the Odin's Re-partition option is NOT ticked.
  10. Click the Start button, wait for a couple minutes until the installation finishes.

You may also perform the factory data reset to obtain a fresher and cleaner firmware installation. Doing so after every new update is installed will get rid of lag issues.